Name: Maxtrol ATTRITION TEST SYSTEM
Model:
Brand: Maxtrol
Application: frictional wear
Category: Frictional Wear Test
Standard: ASTM D5757
Feature:

maxtrol

ATTRITION TEST SYSTEM

ATTRITION TEST SYSTEM 

  • Conforms to ASTM D5757
  • Modular construction for easy maintenance
  • Accurate positioning,easy removal of attrition tube
  • Flexible air hose with quick-connect for easy attachment to attrition tube
  • Particies/fines separation chamber mounted on vertical linear bearings for easy attrition tube removal
  • Precise,stable and repeatable air flow in attrition tube through attrition plate with sapphire orifices
  • Electronically regulated stable air flow
  • Electronic air mass-flow controller
  • Air humidifier built into the system
  • Pressure regulator and gage on air inlet
  • Back-pressure gage to monitor orifice plate pressure
  • Proframmable cycle Timer/Flow-Supervisor allows setting of High and Low flows,and up to four timing cycles of up to 999 minutes each
  • Air inlet solenoid valve controlled by the Timer/Flow-supervisor
  • Menu-driven setup from keypad with LCD display showing flow in engineering units and time left in cycle
  • Beeper to indicate end-of-cycle and end of run
  • RS-232/RS-485 interface allows remote computer setup,monitoring and control
  • Stainless steel attrition tube, orifice plate and separation chamber
  • Air Mass-Flow Control Range:0-15L/Min standard
  • Air Supply Requirements:100 PSI,1 SCFM. 700 kPa,30 lpm.
  • Humidifier Capacity:1 Qt.(750 cc) Deionized Water
  • Power Requirements:110/220 VAC.50/60 Hz,1/-/5A
  • Timing Cycles & Duration:4 Cycles,up to 999 minutes each
  • Attrition Tube:38mmX35mmX710mm
  • Orifice Plate:0.38mm DIA on a 20mm DIA Circle
  • Separation Chamber:630mm Long;Max. Diameter 110mm
  • Space Requirements(each system):0.7m X 2.2m X1m

 

The current number of visitors: 2688385